Miele KM5948 Making the worktop cut-out and building in the hob, Granite and marble worktops

Flush-fitted hobs

Making the worktop cut-out and building in the hob

Granite and marble worktops

eWorktop

fHob

gGap

Corner radius of the worktop ß R4

As the ceramic glass and the worktop cut-out have a certain dimensional tolerance, gap g can vary (min. 1 mm).

^Make the worktop cut-out as shown in "Building-in dimensions".

^Feed the hob connection cable down through the cut-out.

^Centre the hob f in the cut-out.

^Connect the hob to the mains.

^Check that the hob works.

^Seal the remaining gap g with a silicone sealant that is heat-resistant to at least 160 °C.

For granite and marble worktops, only use silicone sealant that is especially formulated for granite and marble, and observe the sealant manufacturer's instructions.

78