Miele KM 326G manual Conversion instructions, Disassembly, For future use, Igniter

Conversion instructions

Caution

Before proceeding with the conversion, shut off the gas supply to the appliance prior to disconnecting the electrical power.

Remove the three screws securing the dual ring wok burner. Remove the wok burner base plate. Lift the ceramic tray from the hob.

Note

Disassembly

Shut off gas supply, disconnect the manifold pipe, disconnect the electrical power. Remove pan supports, burner heads and burner rings. Remove control knobs.

Each regulator shaft is equipped with a black ring. This ring may cling to the rubber seal in the ceramic tray. Check and remove the rings from the rubber seals.

For future use

In the event that the hob is built in, undo the	Save the orifices removed from the appliance
bracket clamps underneath the work surface.	for future use. For converting this appliance
Lift the hob on to the work surface.	back to Natural gas, follow the instructions and
	use the numbers in brackets (… ).
Unscrew the venturis on the high-speed and
super high-speed burners using a 20 mm	Igniter
wrench. Lift and remove the burner rings and	The relationship between the igniter and the
burner base plates. Disconnect the wires from	main burners can't be changed. The relationship
the ignition plugs. Keep the wire from dropping	in the case of LP gas and natural gas is identical.
into the undertray by inserting it in one of the	The distance between the igniter and the high
slots in the burner supports.	speed burner and super high speed burner is
		± 3.5 mm. For the two zone
		high speed burner the
		distance between the
		igniter and the inner ring is
		± 2.5 mm.
Remove the top five screws in the back of the
hob undertray.

20