Minimum adjustment screws
1.Lift and remove the small black ring if this is still on the regulator shaft (see note in "Disassembly").
2.Lift and remove the square black switches. Do not disconnect the wires from the switches or the light emitting diodes (LED).
The wok burner is equipped with two minimum adjustment screws, one for each burner ring.
Note
Make sure you replace both minimum adjustment screws. Put screw 054 (100, natural gas) on the left, 025 (042, natural gas) on the right.
Use a small screwdriver and replace each screw individually.
24
3.Put the black switches with the light emitting diodes back in place.
4.Attach the label 'This control has been converted for use with propane gas' to the top of the hob undertray. Attach it as close to the controls as possible.
5.Fill in the conversion date label and attach conversion kit identification label close to the appliance's original identification plate.
Note
This concludes conversion. The hob can now be reassembled.
Assembly
1.Check that the seals are fitted on the ceramic tray. Put the ceramic tray on the hob. Make sure it is correctly positioned on the undertray. Put the black ring around the regulator shaft as shown. Press the black rings into the seals. Put the control knobs back.
2.Put the wok burner base plate back in place. Fasten the three screws securing the wok burner base plate.
3.Connect the wires to the ignition plugs. Put the
