Miele KM 326G Reattach the gas pipe and tighten the 8 mm ring, gaspipe injector, Reference table

1.First loosen the 8 mm ring securing the gas feed pipe. Disconnect the gas pipe. The actual injector is a thin metal cap mounted between the two brass fittings attached to the left of the wok burner body.

6.Reattach the gas pipe and tighten the 8 mm ring.

Note

gaspipe injector

AB

Inner ring air slot (A)

Inner ring injector

2.Two 12 mm wrenches are needed to separate the fittings.

Use one 12 mm wrench to keep the right- hand fitting in place, while using the other

12 mm wrench to loosen the left-hand fitting.

3.With the left fitting loosened, unscrew the right-hand fitting from the wok burner body.

4.Holding them vertical, take both fittings apart. The metal cap with the injector will remain on top of the lower fitting. Replace the injector cap with the injector cap marked 007 (034, natural gas) and put the two fittings back together.

Warning

Make sure that the natural gas injector is removed from the fitting when the propane gas injector is installed.

5.Screw the assembled fittings back into the wok burner body. Carefully tighten both fittings. Do not overtighten.

Adjust the air slot on the inner ring injector now. The slot is adjusted by shifting the metal clip around the right-hand fitting. Move the clip to obtain a full opening of the hole (A) in the fitting.

Reference table

LP gas
		adjustment
	injector	screw
high-speed burner	0.75 mm	0.36 mm
	0.03”	0.014”
super high-speed burner	0.87 mm	0.40 mm
	0.034”	0.016”
wok burner inner ring	0.50 mm	0.25 mm
	0.02”	0.01”
wok burner outer ring	0.90 mm	0.54 mm
	0.035”	0.021”
natural gas
		adjustment
	injector	screw
high-speed burner	1.45 mm	0.55 mm
super high-speed burner	1.66 mm	0.60 mm
wok burner inner ring	0.60 mm	0.42 mm
wok burner outer ring	1.70 mm	1.00 mm

23