Miele KM 81-2 öInstructions for building-in, bAppliance cTensioning screw d Clamp

]öInstructions for building-in

		Depth	Width *
		in	(= Dimen-
		inch	sion B)
			in inch
2 zone Combiset
1	Combiset	19-5/16"	10-7/16"
2	Combisets	19-5/16"	22"
3	Combisets	19-5/16"	33-1/2"
4	Combisets	19-5/16"	45-1/32"
5	Combisets	19-5/16"	56-9/16"
4 zone Combiset
1	Combiset	19-5/16"	22"
2	Combisets	19-5/16"	45"
3	Combisets	19-5/16"	68"
Combination
One 2 zone
+ one 4 zone		19-5/16"	33-1/2"
Two 2 zone
+ one 4 zone		19-5/16"	45"
Three 2 zone
+ one 4 zone		19-5/16"	56-9/16"
One 2 zone
+ two 4 zone		19-5/16"	56-1/2"
Two 2 zone
+ two 4 zone		19-5/16"	68-1/16"

Extractor (e.g. DA 8-2)

For building in between two appliances: - Dimension B increases by 3 9/16".

For building in at the end of a combination:

-Dimension B increases by 3 7/8".

*Width includes provision for V 98 spacer bar.

Place the seal provided f under the edge of the cooktop.

loosen tighten

bAppliance

cTensioning screw d Clamp

e Countertop f Seal

Turn the tensioning screws c in a - clockwise direction b until a resist- ance is felt, then turn the clamp to the left.

Place the appliance in position, turn the clamps and tighten the tension- ing screws until the clamps just touch the countertop e. Do not over- tighten.

Connect the appliance to the electri- cal supply.

When building-in several Combiset units, a stainless steel spacer bar (V 98 edge connector) must be installed be- tween each unit. It is supplied with its own installation instructions.

27