@äConversion to alternative types of gas
Screw the three screws into the bur- ner base using a suitable cross- slotted screwdriver.
Put the large burner cap base, the burner ring, the large burner cap and the wok/pan support in place. Check whether the lug of the large burner cap is correctly positioned in the notch in the large burner cap base and whether the lug of the large burner cap base is correctly positioned in the notch in the burner base.
After conversion
After converting the gas cooktop unit to an alternative type of gas, place the label supplied with the jet kit on to the data plate over the type of gas stated.
Check that there are no leakages.
Check that the burner is correctly assembled.
Turn on the gas supply.
Turn on the electrical supply.
Light the burner:
When set at “low”, the flame should not go out, nor when the control knob is quickly turned from “high” to “low”.
When set at “high” the gas flame must burn with the clearly visible cen- ter.
40
