Miele KM 81-2 öConversion to alternative types of gas, bFastening screw cAir sleeve

]öConversion to alternative types of gas

Replacing the small jet for the lowest Checking the first intake of air flame setting

Remove screw d from fitting c using an 8 mm wrench and a 12 mm wrench to counterhold.

Then remove the screw fitting c from b using a 12 mm wrench and a second 12 mm wrench to counter- hold.

Replace the restrictor e contained in section b with the correct restric- tor from the table of jets (page 32).

Turn the air sleeve f to adjust the two air vents g to the opening illustrated (2 mm / 1/16").

Assemble removed parts in reverse order and check for leaks by opera- ting the wok burner without the cook- top cover in place (ignite the flame using a match).

bFastening screw

cAir sleeve

Gap X must be 13 mm / 1/2" for both natural and liquid gas.

If this is not the case, loosen the secur- ing screw, re-position the air jet and then tighten the securing screw.

Re-assemble the cooktop in the reverse order.

35