| Problem solving guide | |
|
|
|
|
|
|
Problem | Possible cause | Remedy |
The condenser unit | The inner cover of the | – Ensure that the condenser |
service panel will not | condenser unit has not | unit is positioned correctly |
shut. | been locked properly | and lock the cover. |
| and/or the condenser | – Check the rubber seals. |
| unit has not been |
|
| positioned correctly. |
|
Water leaks from the | Fluff has collected at | – Use a cloth to remove any |
machine after the | the bottom of the | fluff from the inside of the |
condenser unit has | condenser unit housing. | condenser unit housing. |
been cleaned. |
|
|
Check and fault indicator lamps |
| |
|
|
|
Problem | Possible cause | Remedy |
The Empty out | The condensed water | – Empty out the condensed |
container indicator | container is full or there | water container. |
lamp comes on. | is kink in the drain hose. | – Check the drain hose. |
|
| – Before starting a new |
|
| programme, first switch the |
|
| dryer off and then on again. |
The programme has | There is no obvious | – Switch off the dryer. |
been interrupted, the | cause. | – Then switch the dryer back |
indicator lamp for |
| on and start the programme |
Hand iron or Machine |
| again. |
iron is flashing, and |
| If the programme stops again |
the buzzer sounds. |
| |
| and an indicator lamp flashes, | |
|
| |
|
| there is a fault. Contact the |
|
| Miele Service Department. |
25
