Miller Electric Big 40 CAT manual +, Starting Instructions

1 2 3

10

1 + − 4

11

+ −

2 3

7

+ −

89

4 5 6

4 1

+−

3 2

+ −

S-176 108

12

1Warning! Watch Out! There are possible hazards as shown by the symbols.

2Do not smoke and keep matches and flames away from battery.

3Sparks can cause battery gases to explode. Battery explosion can blind and injure. Wear a face shield.

4Battery acid can burn skin. Do not spill acid.

5Read Owner’s Manual.

6Wear rubber gloves.

7Dead battery

8Engine block

9Fully charged battery

10Do not connect last negative cable to dead battery − connect instead to engine block.

11Jumper cables − observe polarity and make connections in numbered sequence shown.

12Once dead battery is charged, disconnect cables in sequence shown.

1

2

S-176 106

1Warning! Watch Out! There are possible hazards as shown by the symbols.

2Moving parts, such as fans, rotors, and belts, can cut fingers and hands and cause injury. Keep away from moving parts.

3/96

Starting Aid Switch. Below 32°F (0°C), push switch up for 60 seconds before starting engine.

Starting Instructions:

1 Press and hold Magnetic Shutdown switch.

2Turn Engine Control switch to Start position.

3Release Engine Control switch and Starting Aid switch (if used) when engine starts.

4Continue holding Magnetic Shutdown switch for 3 seconds after engine starts.

OM-4406 Page 10 Return To Table Of Contents