Miller Electric Big Blue 600D Installation, Installing Welding Generator, Connecting The Battery

SECTION 4 – INSTALLATION

4-1. Installing Welding Generator

Movement

YDo Not Lift Unit From End

Airflow Clearance

18in

(460 mm)

Location

18 in

18 in

(460 mm)

OR

(460 mm)

18 in	18 in
	(460 mm)
(460 mm)

OR

Grounding				Y Always		securely			fasten
					welding	generator			onto
					transport vehicle			or	trailer
		1	2		and comply with all DOT and
					other applicable codes.
	GND/PE
				Y Always		ground		generator
					frame to vehicle frame to pre-
					vent electric shock and static
					electricity hazards.
				Y If unit does not have GFCI re-
					ceptacles,		use		GFCI-
					protected extension cord.
Electrically bond generator frame to				1	Equipment Grounding
vehicle frame	by metal-to-metal
					Terminal (On Front Panel)
contact.			3
				2	Grounding Cable (Not
					Supplied)
				3	Metal Vehicle Frame
				Connect cable			from	equipment
				ground terminal to metal vehicle
				frame. Use #10 AWG or larger
				insulated copper wire.

install1 7/02 – Ref. ST-800 652 / Ref. ST-800 477-A / ST-158 936-A / S-0854

4-2. Connecting The Battery

YConnect Negative (–)

OFF

Cable Last.

+

–

RUN

START

Tools Needed:

1/2 in

ST-153 654-B / Ref. SD-131 784-A / Ref. S-0756-B

OM-481 Page 13