4-3. Installing Exhaust Pipe And Rain Cap
OFF
1
RUN
2
START
Tools Needed:
1/2 in
3
Y Stop engine, and let cool.
1 Exhaust Pipe
2 Muffler Pipe
Install exhaust pipe over muffler pipe. Secure exhaust pipe to top cover using supplied hardware.
3 Rain Cap
Install so cap opens toward front of unit.
Y Do not blow exhaust toward air cleaner or air intake.
Ref.
4-4. Engine Prestart Checks
1/2 in
(13 mm)
Full
Tools Needed:
Diesel
3/8 in
Check all fluids daily. Engine must be cold and on a level surface.
.This unit has a low oil pressure
shutdown switch. However, some conditions may cause
engine damage before the en-
Fullgine shuts down. Check oil lev- el often and do not use the oil pressure shutdown system to monitor oil level.
Follow
Fuel
Y Do not use gasoline. Gaso- line will damage engine.
Add fresh diesel fuel before starting engine the first time (see mainte- nance label for specifications). Fill fuel tank up to 1/2 in. (13 mm) from top to allow room for expansion.
Do not run out of fuel or air enters fuel system and causes starting problems. See engine manual to bleed air from fuel system.
Oil
After fueling, check oil with unit on level surface. If oil is not up to full mark on dipstick, add oil (see main- tenance label).
.To improve cold weather starting:
Keep battery in good condition. Store battery in warm area off concrete surface.
Use fuel formulated for cold weather (diesel fuel can gel in cold weather). Contact local fuel supplier for fuel in- formation.
Use correct grade oil for cold weather.
