Miller Electric DS-75D12 Installing Welding Gun, Installing gun without, Accu-Mate connection

4-15. Installing Welding Gun

3

4

1	2	1	2
			804 730-A
Installing gun with		Installing gun without
Accu-Mate connection		Accu-Mate connection

1Gun Locking Tab

2Power Clamp Knob

3Power Pin Groove

4Gun Connection End

Installing gun with Accu-Mate connec- tion

Loosen power clamp knob to allow power pin of gun to clear the gun locking tab.

When installing gun, the liner should extend

into the PD continuous guide (or exit guide if used) as far as possible without interfer- ing with the guide.

Align the groove in the power pin of the gun with the gun locking tab.

Secure gun by tightening power clamp knob.

Installing gun without Accu-Mate con- nection

When using a gun without the groove in the power pin, loosen power clamp knob and rotate gun locking tab 180 degrees. This prevents the locking tab from extending into the power pin gun connection.

When installing gun, the liner should extend into the PD continuous guide (or exit guide if used) as far as possible without interfer- ing with the guide.

Secure gun by tightening power clamp knob.

OM-230 300 Page 18