6-6. Troubleshooting Torch
Does arc go on and off while cutting?
No
Does arc go out while cutting?
No
Yes
Yes
Torch travel speed too slow; increase travel speed (see Section
Be sure work clamp is securely attached to work- piece. Make sure tip is on or near, 1/16 in (1.6 mm) to 1/8 in (3.2 mm) workpiece (see Section
Go to Section
Go to Section
Do sparks come out of top of cut; or cut is not clean?
No
Is Trouble light On; unit has no cutting output?
No
Go to Section
Yes
Yes
Torch travel speed too fast; reduce travel speed (see Section
Check torch shield cup (see Section
Go to Section
*Servicing procedure to be performed only by authorized Service Station.