Miller Electric XLT 185 Installation, Installing Welding Gun, Close door, Incorrect, Correct

SECTION 5 − INSTALLATION

5-1. Installing Welding Gun

4

2

3

1

.Be sure that gun end is tight against drive assembly.

3 3

1Drive Assembly

2Gun Securing Thumbscrew

3Gun End

Loosen thumbscrew. Insert end through opening until it bottoms against drive assembly. Tighten thumbscrew.

Welding gun must be inserted completely to prevent leakage of shielding gas.

4 Gun Trigger Leads

Insert leads, one at a time, through gun opening on front panel. Connect female friction terminals to matching male terminals in unit. Polarity is not important.

Close door.

	Exposed O-rings
Incorrect	will cause shielding	Correct
	gas leakage.
Gun Not Seated		Gun Fully Seated

804 621-A

OM-230 832 Page 11