Miller Electric XLT 185 warranty Installing Contact Tip And Nozzle

5-9. Installing Contact Tip And Nozzle

	Y	Turn off welding power source.
	1	Nozzle
	Remove nozzle.
	2	Contact Tip
	3	Tip Adapter
	Thread welding wire through gun (see
3	Section 5-10).
2	Slide contact tip over wire and tighten
	tip into tip adapter.

Install nozzle.

1

Flux Nozzle

Use with flux cored wire only. Narrow design allows access in tight spaces and provides better visibility of puddle during welding.

Push nozzle over contact tip and adapter until it is seated onto adapter. Contact tip will be exposed approximately 7/16 in (11.3 mm) when installed properly.

MIG Nozzle

Use with solid or flux cored wire.

Push nozzle over contact tip and adapter until it is seated onto adapter. End of contact tip will be flush with end of nozzle when installed properly.

Tools Needed:

Ref. 802 399-A

OM-230 832 Page 17