Windows XP Wireless Options | Mitsubishi Electronics A111 specs

Chapter 3 - Reference

Windows XP Wireless Options

The wireless option shown below is only available for Windows XP. The first time you run the Control Center utility, it will automatically show. Select one of the radio buttons to decide which interface to use with your WLAN Card.

Only use XP wireless function – Only use “Windows XP” wireless network settings to configure the A111 card.

Only use Diamond Digital utilities and disable XP wireless function

–Only use “A111 Card utilities” to configure the A111 card. (recommended)

Software Reference

Chapter 3

You can return to the Wireless Option setting at any time by left clicking the control center icon and choosing Wireless Option.

A111 Wireless Card Adaptor

13

Image 13

Mitsubishi Electronics A111 user manual Windows XP Wireless Options

Contents

Wireless Card Adaptor User’s Manual A111 Wireless Card Adaptor Disclaimer Installation InstallationProceduresSystem Requirements ClickInstallA111WLANCardUtilities/Driver Installation Installing the A111 utilities and driver Configuring the Wlan utility Quick Start Soft AP Windows XP Only Select Soft AP Mode Access Control and WDS Settings Soft AP Access Control and WDSAccess Control Network Range Extension To disable this function LNK Link LED Reading the A111 Status IndicatorsACT Activity LED Reference ChapterOverviewAdditional Reference Windows XP Wireless Options A111ControlCenter Using the Control Center TaskbarStarting the Control Center manually Reference Wireless Status Icons on the taskbar Reference Taskbar Icon Right Menu Taskbar Icon Launch Wireless SettingsTaskbar Icon Left Menu Starting Wireless Settings Wireless Settings UtilityStatus Status Tab MAC address Reference Association StateCurrent Channel Current Data Rate Reference Radio State Activate ConfigurationSave as Profile Status Connection Tab Frame ErrorFrame Sent/Received Connection Quality Button Status IP Config Tab As Wireless LAN Config Basic TabNetwork Type Network Name Ssid Data Rate Reference ChannelOthers Data encryption WEP enabled Config Encryption TabWireless Network Key Two ways to assign WEP keys Default Key Reference 64/128-bit versus 40/104-bit Buttons Survey Site Survey Tab About Version Info Tab Link State Exit Wireless Settings Ad Hoc Software Reference Wireless Properties Chapter Windows XP Wireless Properties Reference Windows XP Wireless Properties Verify if the A111 card is installed correctly TroubleshootingCannot connect to any Access Points Verify that the Network Type is in Infrastructure mode Cannot connect to a Station A111 Card Bad link quality or bad signal strength Glossary Cofdm for 802.11a or 802.11g Default KeyDevice Name DNS Server Address Domain Name System Dhcp Dynamic Host Configuration ProtocolDSL Modem Digital Subscriber Line Direct-Sequence Spread Spectrum for 802.11b Essid Extended Service Set Identifier Extended Service Set ESSEncryption Ethernet Ieee 802.11a 54Mbits/sec Ieee Ieee 802.11b 11Mbits/sec ISP Internet Service ProviderIeee 802.11g Infrastructure LAN Local Area Network MAC Address Media Access ControlNAT Network Address Translation NIC Network Interface Card Weca Wireless Ethernet Compatibility Alliance Ssid Service Set IdentifierPreamble Radio Frequency RF Terms GHz, MHz, Hz WPA Wi-Fi Protected Access Wlan Wireless Local Area Network Service Contacts Western Australia