Mitsubishi Electronics WT-42413 DTV Receiver with RGB Video Connections, Green Blue Pb/B Red Pr/R

Connecting a DTV Receiver, continued

Note: The TV back panel and connections shown here are for reference only and may vary by model.

�� ���� ����� �������� �������
				���������			���������� ����� �
				��� � � �����	�����
				�	�		���� � ���� ����� �
�������		� � � � �
���	�	�	�	�	�	�
			�			�
			��	�	�	�	�	�
			�
			�������			��
				��	�			�
			� �������	� �		�
				�			�
				����� �			�	�����
			���������� �
				� � �� �
			������

�����	����� �	�	���
������
	�����

�� � � �	��� �	�� �� �
	���
IR EMITTER
REPEATER	NetCommand IR

��� �������� ����� ��� ������������

	�������
	���� �� ���������� �����
�����	�� ��� ����

�	�	�	�	�����
			�
			�������	��� �� ��

		�	�		���	�� �
	�			�		�� �
			�		�������
	��				����� ���
	�	�	�
		�
����� ����	������	�		�������		�� ���� ���	��������� ��

�

��

�

�� ��������

����� �� ���������

�

��

�

Figure 13. Connecting the DTV receiver with RGB

video connections.

See Appendix B, page 67 for component video signal compatibility information.

For digital audio connections, see your DTV receiver and A/V receiver Owner’s Guides.

DTV Receiver with RGB Video Connections

(Figure 13)

1.Connect the outside antenna, cable, or satellite to ANT or SATELLITE IN on the DTV receiver (see your DTV receiver owner’s guide for instructions and cable compatibility).

2.If your DTV receiver has a built-in terrestrial tuner, connect the incoming terrestrial antenna to ANT on the DTV receiver. If your DTV receiver does not have a built-in terrestrial tuner, this TV will only be able to provide an analog signal through Ant-A on the TV back panel.

3.Connect the RGB cables from the DTV receiver to the TV back panel as listed below (if your DTV receiver uses BNC-type cables, use the adaptors shown in Figure 11, page 19):

DTV Receiver		TV Back Panel
G (green)	=	Y/G
B (blue)	=	Pb/B
R (red)	=	Pr/R

4.If the DTV receiver has outputs for H and V sync, connect as listed below (DO NOT connect if DTV receiver uses “Sync on Green”):

H (horizontal sync)	=	H
V (vertical sync)	=	V

5.Connect the L (left) and R (right) audio cables from the DTV receiver to DTV AUDIO on the TV back panel.

6.To utilize the benefits of a digital A/V receiver, connect your DTV receiver’s digital audio out to a digital input on your digital A/V receiver.

You may need to setup the DTV (See Input Assignment, page 35 for WT-42413 or page 38 for WS-48413, WS-55413, WS-65413) to RGB.

20