Mitsubishi Electronics ws-48413 manual Follow the steps below to install and remove Diamond Shield

Appendix E: Diamond Shield™ Installation and Removal for Models WS-, WS- and WS-

Follow the steps below to install and remove the

Diamond Shield.

INSTALLATION

A. Begin by inserting the shield, sliding it into the channels, starting at the bottom. Gently bow the Diamond Shield toward you and insert the Diamond Shield into the top channel.

B. Install the left and right molding clips by pressing them into the opening starting at a corner. Do not force the clip. The clip will slide into place. This completes the Diamond Shield installation.

REMOVAL

To remove the Diamond Shield, reverse the order of the above procedure.

Diamond Shield Installation

WARNING

Sharp edges! Always wear gloves to handle, lift and install Diamond Shield and molding clips.

Molding Clips

The Diamond Shield for the WT- is not designed to be removed by the customer.

71