Mitsubishi Electronics ws-48413, WT-42413 manual Use of the Remote Control with Other A/V Products

Use of the Remote Control with Other A/V Products

For WS-48413, WS-55413 and WS-65413, the following information is not applicable if you are using NetCommand® IR.

Programming the Remote Control to Use with Other Brands of Audio and Video Products:

(Figures 1-3 this page, figures 4-5 following page)

1.Move the slide switch at the top of the remote to the product you want to control.

2.Press and hold the POWER button on the remote control.

3.Enter the first three digit code listed for your equipment, and then release the POWER button on the remote control.

4.Point the remote control to the equipment and press the POWER button.

Note: If the equipment responds, the remote control is properly programmed to operate the equipment. If the equipment does not respond, repeat steps 2-4 with the next three digit code listed in step 3 for your equipment.

When set to TV, the PLAY, STOP, REW/REV, and FF/FWD buttons will operate the VCR after the VCR codes have been properly programmed into the remote control.

	CABLE/DBS/DTV		VCR		DVD
	TV					AUDIO	2.POWER
1.
3.		Cable Box Codes
	Cable box brand			Code to enter:			If your
	General Instruments/			119, 120, 121, 122,123,			cable box
	Jerrold			124			code is not
							listed here,
	Motorola			125, 126, 127
							please see
	Oak			139, 137, 102
							page 68
	Pioneer			101, 116
							for a
	Scientific Atlanta			112, 113
							complete
	Zenith			117, 100
							listing.

To reset to default code, enter 000

Figure 1. Programming the remote to control your cable box.

If you cannot turn the cable box ON by pressing POWER, try pressing CHANNEL or the number buttons.

	CABLE/DBS/DTV		VCR	DVD
	TV				AUDIO	2.POWER
1.
3.		Satellite		Receiver Codes
	Satellite brand			Code to enter:		If your
	Mitsubishi DTV - DBS			006		satellite
	DishNetwork			175		receiver
	Hughes - DBS			173		code is not
						listed here,
	Panasonic - DBS			174
						please see
	RCA - DBS			176
						page 69
	Sony - DBS			177
						for a
	Toshiba-DBS			170, 173, 189, 190, 191
						complete
	To reset to default code, enter 000
						listing.

Figure 2. Programming the remote to control your satellite receiver.

	CABLE/DBS/DTV	VCR		DVD
	TV				AUDIO	2.POWER
1.
3.			VCR Codes
	VCR brand		Code to enter:			If your
	Mitsubishi		001, 002			VCR
	Hitachi		020, 043, 065			code is not
						listed here,
	JVC		030, 054
						please see
	Phillips / Magnavox		043, 044, 051
						page 69
	Panasonic		041, 042, 043
						for a
	RCA		020, 053, 065
						complete
	Sony		048, 049, 050
						listing.
	Toshiba		021
	To reset to default code, enter 000

Figure 3. Programming the remote to control your VCR.

27