Mitsumi electronic WD3300U Using the remote control, Operational range of the remote control

Using the remote control

Operational range of the remote control

Front of projector Rear of projector

30° 30° 30° 30°

Operate the remote control within a distance of 10 m (30 feet) from the projector, pointing the light beam at the remote control photo-sensor (front or rear) of the projector.

•Keep the remote control photo-sensor out of direct sunlight or fluorescent lamp light.

•Keep the remote control photo-sensor at least 2 m

(6 feet) away from fluorescent lamps. Otherwise, the remote control may malfunction.

•If there is an inverter-operated fluorescent lamp near the remote control, the remote control operation may become unstable.

•When you use the remote control too close to the remote control sensor, the remote control may not work correctly.

When operating the remote control, keep the distance from the remote control to the projector via the screen within about 5 m (15 feet). The operable range of the remote control, however, depends on the characteristics of the screen.

Reception angle

Vertical directions

20°

10°

Vertical directions (ceiling mount)

20°

10°

20°

20°

Using the wired remote control

Attached remote control for this projector can be used as a wired remote control with remote control cable. Wired remote control is useful for operating in a distance or outside of the operating area.

REMOTE IN

REMOTE IN REMOTE OUT

•For connection, use the pin-pin cable of ø3.5 stereo type, which is commercially available. However, some cable may not work correctly.

•When REMOTE OUT terminal on this projector is connected to the REMOTE IN terminal on the other projector, the two projectors can be controlled together by using the remote control.

•When the remote control is connected with remote control cable, it does not work as a wireless remote control.

•When using the wired remote control, the laser beam may be darker. It is normal.

EN-9