Replacing the lamp (continued)
When removing the lamp from the ceiling-mounted projector
When removing the lamp from the
• Assemble the lamp replacement tray according to the procedure shown on it.
1.Follow steps 1 to 4 on page 43.
2.Attach the lamp replacement tray to the projector as shown in the figure.
3.Secure the lamp replacement tray on the projector using the tape packed with the tray.
Tape
4.Pull out the lamp box by the handle while holding the projector.
•Hold the lamp replacement tray to prevent glass fragments from scattering.
•Don’t put the lamp directly on the lamp replacement tray
because it may fall.
5.Detach the lamp replacement tray together with the removed lamp.
6. Follow steps 6 to 11 on page 43.
Maintenance
Warning:
•Do not use flammable solvents (benzene, thinner, etc.) and flammable aerosols when cleaning the projector body
and lens. Flammable substances may ignite causing fire or breakdown while the lamp is illuminating.
Caution:
•Be sure to turn off the lamp and unplug the power cord from the wall outlet before you perform any maintenance on the projector.
Cleaning of the projector and the ventilation slots
Use a soft cloth to clean the projector and the ventilation grilles. When the grilles become dirty, wipe them with a soft cloth dampened with diluted mild detergent, and then wipe them with a dry cloth.
•Clean the inside of the terminal cover frequently as dust is apt to be collected.
To protect the surface of the projector from fading or deteriorating:
•Do not spray insecticide on or inside the projector.
•Do not use benzine or thinner to clean it.
•Do not let rubber or plastic materials contact with projector.
Cleaning of the lens
Use a standard
