Viewing computer images (continued)
9. Press the ZOOM/FOCUS button to display the ZOOM/FOCUS menu. 10.Adjust with the p or q button to get an approximate size.
•When the ENTER button is pressed while the ZOOM/FOCUS menu is displayed, the adjustment mode is switched between FAST and STEP. When FAST is selected, the speed of zoom controlled by the p or q button becomes fast, and it becomes slow when STEP is selected.
11.Press the LENS SHIFT button. The LENS SHIFT menu appears at the center of the screen.
12.Press the p or q button to adjust the vertical position and or button to adjust the horizontal position of the displayed image.
•When the image is not displayed within the screen, adjust the projection angle. In addition, perform the keystone adjustment, if necessary. (See page 11.)
Repeat steps 4, 5 and 9 to 12, if necessary.
Important:
• Focus, zoom and lens shift adjustment is possible in the normal picture mode only.
To stop projecting:
13.Press the POWER button.
•A confirmation message is displayed.
•To cancel the procedure, leave the projector for a while or press any button except the POWER button.
14.Press the POWER button again.
•The lamp goes out and the projector goes into a standby mode. In this standby mode, the STATUS indicator blinks green.
15.Wait about 2 minutes for the STATUS indicator to be turned off.
•During this period of 2 minutes in the standby mode, the intake fan and exhaust fan rotate to cool the lamp.
•The air outlet fans rotate faster as the temperature around the projector rises.
•Though the fans make loud sounds during cooling, such symptom is not a malfunction.
16.Turn off the main power switch.
•The POWER indicator will go out.
•If the main power switch should be turned off or the power cord should be unplugged accidentally while either the air inlet fan or the air outlet fans are operating or the lamp is on, allow the projector to cool down for 10 minutes with the power off. To light the lamp again, press the POWER button. If the lamp doesn’t light up immediately, repeat pressing the POWER button 2 or 3 times. If it should still fail to light up, replace the lamp.
•Cover the lens with the lens cap to protect it from dust.
•For safety’s sake, unplug the power cord from the outlet.
•When you repeat turning off the main switch within 30 minutes from the lamp illumination, an error may occur in the clock function of this product.
Instant Shut Down
You can turn off this projector just by turning off the power switch or unplugging the power cord without pressing the POWER button.
•Don’t shut down the projector while the STATUS indicator is blinking after the lamp lights up because the lamp’s life may be shortened.
•Don’t turn the projector back on right after shutting it down because the lamp's life may be shortened. (Wait about
10 minutes before turning the projector back on.)
•Before shutting down the projector, be sure to close the menu screen. If you shut down the projector without closing the menu, the setting data of the menu may not be saved.
•If you shut down the projector while controlling the projector using the network function, the application software such as ProjectorView may fail. For details, see “User Guide of LAN Control Utility” contained in the
