C a l i b r a t i n g t h e S u p p l y
1. Turn off the printer.
2. Press and hold the FEED button while turning on the printer.
3. Release the FEED button after the indicator light starts flashing ORANGE. The printer calibrates the die cut sensor, measures the label length, and prints the test labels.
4. To resume normal printing, turn off the printer, wait two seconds, then turn it back on again.
If the supply does not calibrate, make sure the die cut sensor has not been accidentally moved.
C h e c k i n g t h e D i e C u t S e n s o r
After loading supplies, make sure you did not accidentally move the die cut sensor. The die cut sensor senses and calibrates the supply. For your supplies, make sure the die cut sensor is in the detented position and the middle of the square lens lines up with the arrow inside the printer.
Sensor set for die cut supplies
Getting Started