Chapter 2. Loading Ribbon and Supplies
DO NOT wrinkle or crush the ribbon.
5.With the ridged end of the
6.Feed the ribbon around the guides and place the
7.Twist the ribbon roll back and forth as you firmly push it down until it is seated on the spool.
Do not force the ribbon roll down onto the spool; you could damage the foam washer. Also, make sure the preprinted side of the ribbon faces out. Make sure the latches are still in the unlocked position ( 
) before fitting the two halves of the cassette together.
8.Replace the other half of the cassette. The two halves should fit together completely.
9.Rotate the latches until they click into the locked position ( 
).
10.Check to make sure that the ribbon is loaded correctly and that the ribbon is wound tightly inside the cassette. Turn the gear counterclockwise with your fingers until the black portion of the ribbon is exposed.
11.If the ribbon does not advance, or if it is hard to turn the gear, repeat the loading procedure.
