IDV380/IDV490 Fireplace Insert | IMPORTANT SAFETY INFORMATION and code approval |
Continued from page 3
15.This appliance, when installed, must be electrically grounded in accordance with local codes or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1.
16.Do not obstruct the flow of combustion and ventilation air in any way. Provide adequate clearances around air openings into the combustion chamber along with adequate accessibility clearance for servicing and proper operation.
17.Do not use insert if any part has been exposed to or has been under water. Immediately call a qualified service technician to inspect the appliance and replace any part of the control system and any gas control which as been submerged in water.
18.Do not operate insert if any log is broken.
20.Do not operate the insert with glass door removed, cracked, or broken.
!WARNING
|
|
|
|
|
| HOT GLASS WILL |
|
|
|
|
|
|
|
| |
|
|
|
|
|
| CAUSE BURNS. |
|
|
|
|
|
|
| DO NOT TOUCH GLASS |
|
|
|
|
|
|
| UNTIL COOLED. |
|
|
|
|
|
|
| NEVER ALLOW CHILDREN |
|
|
|
|
|
|
| TO TOUCH GLASS. |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
WARNING | Never connect unit to private |
| |||||
gas wells. This gas is commonly known |
| ||||||
|
|
|
|
| |||
|
|
|
| as wellhead gas. |
| ||
|
|
|
|
|
|
|
|
IMPORTANT:
PLEASE READ THE FOLLOWING
CAREFULLY
It is normal for fireplaces fabricated of steel to give off some expansion and/or contraction noises during the start up or cool down cycle. Similar noises are found with your furnace heat exchanger or car engine.
IMPORTANT:
PLEASE READ THE FOLLOWING CAREFULLY
It is not unusual for gas fireplaces to give off some odor the first time it is burned. This is due to the manufacturing process.
Please ensure that your room is well ventilated during burn off — open all windows.
It is recommended that you burn your fireplace for at least ten (10) hours the first time you use it. Place the fan switch in the “OFF” position during this time.
Code Approval
Direct Vent type appliances draw all combustion air from outside of the dwelling through the vent pipe.
These appliances have been tested by CSA and found to comply with the established standards for DIRECT VENT GAS FIREPLACE HEATERS in the USA and Canada as follows:
LISTED VENTED GAS FIREPLACE HEATER
TESTED TO: ANSI
A manufactured home (USA only) or mobile home OEM installation must conform with the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280, or when such a standard is not applicable, the Standard for Manufactured Home Installations, ANSI/NCSBCS A225.1, or Standard for Gas Equipped Recreational Vehicles and Mobile Housing, CSA Z240.4.
57D0016
