Monessen Hearth IDV490PVC Installation, Insert Placement, IDV380/IDV490 Fireplace Insert, 57D0016

INSTALLATION IDV380/IDV490 Fireplace Insert

INSERT PLACEMENT

•The insert must be placed within a code-conforming masonry fireplace or a tested and listed zero-clearance (UL-127, solid fuel) fireplace. Repair any fireplace damage prior to installation.

•Because the insert uses a circulation blower, clean the fireplace, smoke shelf and chim- ney before installing.

•This heater may be placed in a bedroom. Please be aware of the large amount of heat this appliance produces when determining a location.

For minimum dimensions, Refer to Page 7

For minimum dimensions, Refer to Page 7

For tight fits you may remove the manifold. Refer to "Remove the Manifold" Section

The insert protrudes into the fireplace. Refer to Page 7 for dimensions.

FP2624

Figure 5 -

Insert Placement

Run the on/off switch wires to the right - behind the surround panels

The gas line should be installed prior to insert placement

Use the leveling bolts for fireplaces with recessed floors

Run the power cord either side of the insert along the face

57D0016