STEP 7 Analog Audio AC Outlet Hookup
Isolated Clean Power Stage 4 Analog Audio Filter: Optimized to provide maximum noise rejection for sensitive analog audio components.
NOTE:
Because certain components don’t need to, or shouldn’t be turned on continuously, you should program these outlets to be “switched on”(see page 7, fig. 2b). This means the components plugged into these outlets won’t receive power or shut down unless your PowerCenter is turned on or off.
You can plug any type of low current analog audio component (e.g., preamplifier, tape deck) into the corresponding PREAMP or TAPE outlet.
A)Attach a Monster Power® ID label to each component’s power cord before you plug it into the appropriate
B)PREAMP: Plug your preamplifier’s power cord into the PowerCenter’s corresponding PREAMP outlet.
C)TAPE: Plug your tape deck’s power cord into the corresponding TAPE outlet.
IN | CABLE TV | OUT | NORMAL |
OUTLET PROGRAMMING SWITCHES
REMOTE
UNSWITCHED SWITCHED DELAY NO DELAY
1 | IN | OUT 1 |
2 |
|
|
SATELLITE
1 | 2 | 3 | 4 | 5 |
INOUT
3
4
5
REMOTE
AC INPHONE
110V
OUT 2
GROUND |
| SHORT | LONG | DELAY TIME |
|
|
|
| (6 seconds) | (20 seconds) SWITCH |
|
| |
|
| DELAY | NO DELAY | TRIGGER OUT | DC IN |
|
|
|
|
| SWITCH |
| |
|
|
|
|
| 9~12V 300MA |
|
|
|
| DC OUT 9~12V 300MA |
|
| |
IN | ANTENNA | OUT |
|
| BREAKER 15A |
|
|
|
|
|
| PRESS TO RESET | 1800W MAX TOTAL |
13
