Motorola RDV2080d, RDU2080d manual Yes, Programming Scan List

transmitting without having to switch channels by pressing PTT.

•To stop scanning, short press the SB2 button again.

•If you press the PTT button while the radio is scanning, the radio will transmit on the channel which was selected before you activated Scan. If no transmission occurs within five seconds, scanning will resume.

•If you want to scan a channel without Interference Eliminator Codes (CTCSS/DPL), set the code settings for the channels to ‘0’ in the CTCSS/DPL Programming Selection Mode.

Whenever the radio is set up in ‘Scan Mode’ the LED will signal a fast red blink.

Note: (*) Assumes the SB2 button is not programmed to other function different from the default. If Auto-Scan has been enabled for a particular channel, do not press SB2 button to start scanning, as the radio will do it automatically.

Programming Scan List

You can enable/disable the Channel Scanning feature for each channel in your radio. To do so, enter ’Programming Mode’ and select the channel you want to program. Scroll through the programming options by short pressing the PTT button until you reach the ‘Scan Programming Mode’. The radio display will show the scan icon Gas follows:

YES

Both the channel number and current scan setting (YES=ON or NO=OFF) will be blinking on the display, indicating that you can choose your setting. To set the channel number, press the / buttons until you reach the desired channel number.

PROGRAMMING FEATURES

49English