Motorola SM56 guide

Table 3: AT* (Asterisk) Commands

Command	Option	Description

	*MM14	K56flex™ Auto-modulation

	*MM15	V.90 Only

	*MM16	V.90 Auto

	*MM17	V.92 Only

	*MM18	V.92 Auto

12

Image 14

Motorola SM56 manual MM14 K56flex Auto-modulation MM15 Only MM16 MM17 MM18

Contents

AT Command Reference Manual UbiSurf SM56 Introduction Page AT and AT& Commands Speaker Control Speaker VolumeReturn to On-Line Mode Pulse Dial Result-Code Format Reset Modem Parameters to Default ConfigurationTone Dial Select Call-Progress Result Codes to Return Pulse Cycle Initialize modem to default factory configurationDial TX Level CTS Control AT% Percent and AT\ Backslash Commands Maximum Modulation Rate Minimum Modulation Rate Data Compression DC ModeDisconnect Buffer Delay AT% Percent and AT\ Backslash Commands DTE Flow Control Error-Correction EC ModeBreak Handling Method Disconnect on DTE Inactivity Dial Wait AT* Asterisk CommandsModulation Mode Low-Speed Operation Protocol MM14 K56flex Auto-modulation MM15 Only MM16 MM17 MM18 +A8T 8bis Signal and Message Control AT+ Plus Commands+A8E Configuration +DS +DRData Compression DC Reporting Data Compression Control +ES +EB+ER Synchronous Access Mode Configuration +ESA +FLO +ETBM+FCLASS +FMR? +FMI?+FMM? +FRH AT+ Plus Commands +GMR +GMI+GMM +IFC +MR +PMHT +PCW+PMH +PQC +PMHR+PMF +VCID +VGT +VEM+VGR +VIP +VSD +VRID+VRX +VTS +VSM+VTD Enter Voice-Transmission Mode +VTX ATS S-Register Commands S12 Escape Code Guard Time S18 Test TimerS11 Tone Length S92 Modem-on-Hold Messaging Monitoring AT#UD Last Call Status Report Format Command SyntaxCommand Response Ffffffff Call Setup Result Codes Multimedia modes DTE-DCE modes ErrorControl Active from 3.5.2/V.58 GstnModulationSchemeActive from 3.7.2/V.58 CompressionActive from 3.2.2/V.58 CallCleared codes from 3.6.4/V.58-1994 CallCleared codes from 3.6.4/V.58-1994 Modem response line Description Event Reporting Word Busy