Cisco Systems RVL200 Chapter Installation, Physical Installation, Horizontal Placement, 64.4 mm

Chapter 3

Chapter 3:

Installation

Physical Installation

There are three ways to place the Router. The first way is to place it horizontally on a surface, so it sits on its four rubber feet. The second way is to stand the Router vertically on a surface. The third way is to mount it on a wall.

Horizontal Placement

The Router has four rubber feet on its bottom panel. Set the Router on a flat surface near an electrical outlet.

WARNING: Do not place excessive weight on top of the Router; too much weight could damage it.

Vertical Placement

1.Line up the edges of the Router with the two stands.

2.Insert the Router into the stands.

3.Set the Router on a flat surface near an electrical outlet.

Installation

Wall-Mounting Placement

The Router has two wall-mount slots on its bottom. The distance between the two slots is 64.4 mm (2.535 inches).

Two screws are needed to mount the Router.

Suggested Mounting Hardware

5.0-6.0 mm	1.6-2.0 mm	-3.8 mm
		3.0

†Note: Mounting hardware illustrations are not true to scale.

NOTE: Linksys is not responsible for damages incurred by insecure wall-mounting hardware.

Follow these instructions:

1.Determine where you want to mount the Router. Make sure that the wall you use is smooth, flat, dry, and sturdy. Also make sure the location is within reach of an electrical outlet.

2.Drill two holes into the wall. Make sure the holes are 64.4 mm (2.535 inches) apart.

3.Insert a screw into each hole and leave 5 mm (0.2 inches) of its head exposed.

4.Maneuver the Router so the wall-mount slots line up with the two screws.

5.Place the wall-mount slots over the screws and slide the Router down until the screws fit snugly into the wall-mount slots.

64.4 mm

Print this page at 100% size. Cut along the dotted line, and place on the wall to drill precise spacing.

Wall Mounting Template

4-Port SSL/IPSec VPN Router