Cisco Systems RVL200 SNMP Notification Recipient, Basic, Base Table, Advanced Table, SNMPv1,2

Chapter 4 Advanced Configuration

Select how you want to define the access control of this community.

Basic

Access Mode  This allows both v1 and v2c operation requests. Select Read Only if you want the user to have read-only access to the parameters of the MIB tree with respect to the view name.

Select Read Write if you want the user to have read/write access to the parameters of the MIB tree with respect to the view name.

Select SNMP Admin if you want the user to have full access to parameters of the MIB tree.

View Name  Select View Name and then select the appropriate MIB OID. If View Name is not selected, the option, default, will be assigned.

Advanced

Group Name  Select a group, either v1 or v2c, to assign to this community.

Click Add to List, and configure as many entries as you would like, up to a maximum of 15.

Base Table

The basic entries are listed. To delete an entry, select it and click Delete.

Advanced Table

The advanced entries are listed. To delete an entry, select it and click Delete.

Click Save Settings to save your changes, or click Cancel Changes to undo them.

SNMP > Notification Recipient

Define the types and frequencies of the notifications.

SNMP > Notification Recipient

Notification Recipient

Recipient IP  Enter the IP address that will receive the SNMP traps.

Notification Type  Select the appropriate type, Trap or Inform. An Inform type requires response, while a Trap type does not.

UDP Port  Enter the destination port number. The default is 162.

Timeout  If you selected Inform as the Notification Type, then enter the number of seconds the Router waits before re-sending an inform request. The default is 15 seconds.

Retries  If you selected Inform as the Notification Type, then enter the number of tries you want the Router to re- send an inform request. The default is 3.

SNMPv1,2

Select this option if you want to use a v1 or v2 trap. If you selected Inform as the Notification type, this option will not be available (v1 does not use inform requests).

Then configure the following:

Community String  Enter the password used to authenticate the management station to the Router.

Notification Version  Select the appropriate version, SNMPv1 or SNMPv2.

4-Port SSL/IPSec VPN Router 46