UDP Mode

Delimiter 1

Setting

Factory Default

Necessity

00 to FF

None

Optional

 

 

 

Delimiter 2

 

 

 

 

 

Setting

Factory Default

Necessity

00 to FF

None

Optional

Once the NPort receives both delimiters through its serial port, it immediately packs all data currently in its buffer and sends it to the NPort’s Ethernet port.

Note: Delimiter 2 is optional. If left blank, then Delimiter 1 alone trips clearing of the buffer.

Delimiter 2 is optional. If left blank, then Delimiter 1 alone trips clearing of the buffer. If the size of the serial data received is greater than 1K, the NPort will automatically pack the data and send it to the Ethernet. However, to use the delimiter function, you must at least enable Delimiter 1. If Delimiter 1 is left blank and Delimiter 2 is enabled, the delimiter function will not work properly.

5-20 NPort 5400 Series User’s Manual

Page 46
Image 46
Moxa Technologies 5400 user manual UDP Mode