NPort 5600 Series User’s Manual | Web Console Configuration |
to 1200 bps, 8 data bits, 1 stop bit, and none for parity. In this case, the total number of bits needed to send a character is 10 bits, and the time required to transfer one character is
( 10 (bits) / 1200 (bits/s) ) * 1000 (ms/s) = 8.3 ms.
Therefore, you should set Force transmit timeout to be larger than 8.3 ms, so in this case, it must be greater than or equal to 10 ms.
If the user wants to send the series of characters in the same packet, the serial device attached to NPort should send that series of characters during a time interval less than the Force Transmit timeout for NPort, and the total length of data must be less than or equal to NPort’s internal buffer size. The serial communication buffer size for NPort is 1 KB per port.
Destination IP address 1
Setting |
|
| Factory Default | Necessity | |
IP address range |
| Begin: | Empty | Required | |
E.g., | Begin: 192.168.1.1 |
|
|
| |
End: | Empty |
| |||
| End: | 192.168.1.10 |
|
|
|
| Port: | 4001 |
| ||
|
|
|
| ||
|
|
|
| ||
Destination IP address 2/3/4 |
|
|
| ||
Setting |
|
| Factory Default | Necessity | |
IP address range |
| Begin: | Empty | Optional | |
E.g., | Begin: 192.168.1.11 | End: | Empty |
| |
| End: | 192.168.1.20 |
|
|
|
| Port: | 4001 |
| ||
|
|
|
| ||
|
|
|
|
| |
Local listen port |
|
|
|
| |
Setting |
|
| Factory Default | Necessity | |
1 to 65535 |
| 4001 |
| Required | |
|
|
|
|
|
|
The UDP port that NPort listens to, and that other devices must use to contact NPort. To avoid conflicts with well known UDP ports, the default is set to 4001.
