Multi-Tech Systems MT3334SMI manual +Fbor, +Fcq, +Fcr

Chapter 4 - Class 2 Fax Commands

50 - 69 Transmit phase D hang-up codes

52: No response to MPS repeated 3 times

53: Invalid response to MPS

54: No response to EOP repeated 3 times

55: Invalid response to EOP

56: No response to EOM repeated 3 times

57: Invalid response to EOM

		70 - 89 Receive phase B hang-up codes
		90 - 99 Receive phase C hang-up codes
		90: Unspecified receive phase C error
		100 - 119 Receive phase D hang-up codes
		100: Unspecified receive phase D error
		120 - 255 Reserved codes
+FBOR	Data Bit Order Selection
Command syntax:		+FBOR=<value>
		0: Direct bit order for both Phase C data and for Phase B/D data
		1: Reversed bit order for Phase C data and direct bit order for Phase B/D
		data
		2: Direct bit order for Phase C data and reversed bit order for Phase B/D
		data
		3: Reversed bit order for both Phase C data and for Phase B/D data

Note: Direct bit order: First bit transferred of each byte on the DTE-DCE link is the first bit transferred in the PSTN data carrier.

Reversed bit order: Last bit transferred of each byte on the DTE-DCE link is the first bit transferred on the PSTN data carrier.

+FCQ	Copy Quality Checking
Command syntax:		+FCQ=<value>
		0: Disables copy quality checking. The modem will generate Copy Quality
		OK (MCF) responses to complete pages and set +FPTS=1.

+FCR	Capability to Receive
Command syntax:		+FCR=<value>
		0: Indicates the modem will not receive message data.
		1: Indicates the modem can receive message data.

+FCTCRTY ECM Retry Count

Command syntax:	+FCTCRTY=<value>
	0: Disable error correcting mode retries. Error correcting mode is not
	supported.

MT3334SMI 43