Multi-Tech Systems MT3334ZDXV owner manual Dial string modifiers, Echo Command Mode Characters

MT3334ZDX/V Owner's Manual

Command:	Ds	Dial
Values:	s = dial string (phone number and dial modifiers)
Default:	none
Description:		Dial telephone number s, where s may be up to 40
		characters long and include the 0–9, *, #, A, B, C,
		and D characters, and the L, P, T, V, W, S, comma
		(,), semicolon (;), !, @, ^ and $ dial string modifiers.
	Dial string modifiers:
	L	Redial last number. (Must be placed immediately
		after ATD.)
	P	Pulse-dial following numbers in command .
	T	Tone-dial following numbers in command (default).
	V	Switch to speakerphone mode and dial the following
		number. Use ATH command to hang up.
	W	Wait for a new dial tone before continuing to dial.
		(X2, X4, X5, X6, or X7 must be selected.)
	S	Dial a telephone number previously stored using
		the &Zn=x command (see &Zn=x command for
		further information). The range of n is 0-3.
	,	Pause during dialing for time set in register S8.
	;	Return to command mode after dialing. (Place at
		end of dial string.)
	!	Hook flash. Causes the modem to go on-hook for
		one-half second, then off-hook again.
	@	Wait for quiet answer. Causes modem to wait for
		a ringback, then 5 seconds of silence, before
		processing next part of command. If silence is not
		detected, the modem returns a NO ANSWER
		code.
	$	Calling Card “Bong” Detection
	^	Disable data calling tone transmission.
Command:	En	Echo Command Mode Characters
Values:	n = 0 or 1
Default:	1
Description:	E0	Do not echo keyboard characters to the computer.
	E1	Do echo keyboard characters to the computer.

28