Chapter 2 - Hardware Installation

Introduction

This chapter details the contents of the MTA128ST-USB shipping container, describes each cable connection, and describes the LED indicators.

Unpacking Your MTA128ST-USB

The shipping box contains the MTA128ST-USB, an external power supply, one RJ-45 line cord, one USB cable, your Quick Start Guide, and three diskettes (i.e., MTA128ST-USB User Guide, MTA128ST- USB Driver Software, and ISDN Configuration Utility). Inspect the contents for signs of any shipping damage. If damage is observed, do not power up the unit; contact Multi-Tech’s Technical Support for advice (refer to Chapter 6). If no damage is observed, place the MTA128ST-USB in its final location and refer to “Assembling the MTA128ST-USB” in the next section.

MADE IN U.S.A

MADE IN

U.S.A

 

Figure 2-1. Unpacking

Safety Warning Telecom/ISDN-ST

1.Never install telephone wiring during a lighting storm.

2.Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.

3.This product is to be used with CE approved/marked computers.

4.Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.

5.Use caution when installing or modifying telephone lines.

6.Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electrical shock from lightning.

7.Do not use the telephone to report a gas leak in the vicinity of the leak.

8.To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord.

9.If S/T - interface ISDN network connection cable is used, the ISDN phone cord should be connected between the ISDN network connection cable and a NT1 device.

11