![](/images/backgrounds/138502/138502-11564x1.png)
MultiModemISDN User Guide
S77 V.110 Network Rate Control
S80 Persistent DTR Dialing Delay
Note: V.110 is supported in build
S0 | |
Function: | Number of Rings Until Answer |
Unit: | 1 ring |
Range: | |
Default: | 1 |
Description: Sets the number of rings the TA waits for before it answers and begins its
| connect sequence. S0=0 turns off the ability to automatically answer a call. |
| S0=1 causes the TA to automatically answer after 1 ring. If the S0 value is |
| set too high, the calling device may time out before the TA answers the call. |
| For autoanswer, S0 must have a nonzero value, DTR must be high (&D |
| command), and the TA must be offline. |
S1 | |
Function: | Ring Count |
Unit: | 1 ring |
Range: | |
Default: | 0 |
Description: Counts the number of rings that have occurred, up to a maximum of 255. It is
| a |
| a value other than its default value of zero or if the value is increasing with |
| rings, this new value remains stored in S1 for eight seconds after the last |
| ring is counted, after which time the value reverts to zero. |
S2 | |
Function: | Escape Character |
Unit: | Decimal ASCII code |
Range: | |
Default: | 43 (+) |
Description: Specifies the character used by the TA to escape from data mode and return
| to command mode. |
S3 | |
Function: | Carriage Return Character |
Unit: | Decimal ASCII code |
Range: | |
Default: | 13 (^M) |
Description: Specifies the character used by the TA to indicate the end of a command
| line. |
S4 | |
Function: | Line Feed Character |
Unit: | Decimal ASCII code |
Range: | |
Default: | 10 (^J) |
Description: Specifies the character used by the TA to indicate the end of a status message.
64