MultiVOIP Quick Start Guide
10
5. If you are connecting a station device (analog telephone,
fax machine, or Key Telephone System (KTS)) to your
MultiVOIP, connect one end of an RJ11 phone cord to the
Voice/Fax Channel 1 FXS connector on the back of the
MultiVOIP and the other end to the station device.
If you are connecting a PBX extension to your MultiVOIP,
connect one end of an RJ11 phone cord to the Voice/Fax
Channel 1 FXO connector on the back of the MultiVOIP
and the other end to the PBX extension.
If you are connecting an E&M trunk from a telephone
switch to your MultiVOIP, connect one end of an RJ45
phone cord to the Voice/Fax Channel 1 E&M connector
on the back of the MultiVOIP and the other end to the
trunk. Refer to the User Guide for E&M pin assignments.
If you are connecting to an E&M trunk, you need to ensure
that the E&M trunk jumper is in the correct position for the
E&M type trunk. The default E&M jumper position is E&M
type 2. To change the E&M jumper position, perform the
E&M jumper block positioning procedure in the following
section.
6. Repeat the above step to connect the remaining telephone
equipment to each Voice/Fax Channel on your MultiVOIP.
7. Turn on power to the MultiVOIP by placing the ON/OFF
switch on the back panel to the ON position. Wait for the
BTG LED on the MultiVOIP to go OFF before proceeding.
This may take a couple minutes.
If you need to change the E&M Jumper Block positioning, refer
to the following section. Otherwise, proceed to the Installing
the Software section to load the MultiVOIP software.