61
Deploying the VOIP Network
5. Repeat the above step to connect the remaining telephone
equipment to each Voice/Fax Channel on your MultiVOIP.
6. T urn on power to the MultiVOIP 400/800 by placing the
ON/OFF switch on the back panel to the ON position. Wait
for the BTG LED on the MultiVOIP 400/800 to go off
before proceeding. This may take a couple of minutes.
7. At this time your VOIP network should be fully operational.
Dial one of the sites in your network using the dialing
directory supplied by your network Administrator.
If your H.323 endpoint is not a MultiVOIP 400/800 (for
example, a PC with Netmeeting software), the Systems
Administrator for your VOIP network should do the following:
1. Make certain that the H.323 endpoint (for example, a PC
with Netmeeting, or router with voice) have been properly
connected to the network. Refer to the appropriate end
user documentation.
2. Acquire the relevant IP Addresses and/or H323 IDs (H323
IDs are required if Gatekeeper is enabled) from the other
H.323 endpoints that will participate in H.323 calls.
3. Enter the IP Addresses and MultiTech H323 IDs (H323 IDs
are required if Gatekeeper is enabled) in your phonebook
directory. You do not have to enter non-MultiTech H.323
IDs in the phonebook directory if a gatekeeper is enabled.