Multi-Tech Systems MVP400

MultiVOIP Quick Start Guide

For FXO-to-FXO communications, you can enable a

specific type of FXO Disconnect; Current Loss, Tone

Detection, or Silence Detection. Check with your in-

house phone personnel to verify the preferred type of

disconnect to use. Enabling Tone Detection activates the

Disconnect Tone Sequence options. For Disconnect Tone

Sequence, you can select from lists either one or two

tones that will cause the line to be disconnected. The

person hanging up a call must then hit the key or keys that

will produce those tones. For Silence Detection, select

One Way or Two Way, then set the timer for the number

of seconds of silence before disconnect. The default value

of 15 seconds may be shorter than desired for your

application.

E&M: If you are connecting to an analog E&M trunk on

your PBX, then choose the E&M interface option to enable

the E&M Options group. Check with your local in-house

phone personnel to determine if the signaling is Dial Tone

or Wink and if the connection is 2-wire or 4-wire. If Wink

signaling is used, then the Wink T imer is enabled with a

default of 250 milliseconds. The range of the Wink Timer

is from 100 to 350 milliseconds. Consult with your local in-

house phone personnel for this timer setting.

Note: After configuring a given channel, you can copy that

channel’s configuration by clicking Copy. Everything on

the Interface tab will be copied to the other channel.

15. Repeat the above step to configure the interface type for

each voice/fax channel.