MultiVOIP Quick Start Guide
60
FXSE&M
FXO
PSTN Ethernet Connection
Power Connection
10BASET
ETHERNET POWER
Voice/Fax Channel
Connections
E&M FXO FXS
Figure 5. Remote Site Cable Connection
3. Connect a network cable to the ETHERNET 10BASET
(RJ-45) connector on the back of your MultiVOIP 400/800.
4. If you are connecting a station device (analog telephone,
fax machine, or Key Telephone System (KTS) to your
MultiVOIP 400/800, connect the smaller end of a special
adapter cable (supplied) to the Voice/Fax Channel 1 FXS
connector on the back of the MultiVOIP 400/800 and the
other end to the station device.
If you are connecting a PBX extension to your MultiVOIP
400/800, connect the smaller end of a special adapter
cable (supplied) to the Voice/Fax Channel 1 FXO
connector on the back of the MultiVOIP 400/800 and the
other end to the PBX extension.
If you are connecting an E&M trunk from a telephone
switch to your MultiVOIP 400/800, connect one end of an
RJ-45 phone cord to the Voice/Fax Channel 1 E&M
connector on the back of the unit and the other end to the
trunk phone jack.
If you are connecting to an E&M trunk, you need to ensure
that the E&M trunk jumper is in the correct position for the
E&M type trunk. The default E&M jumper position is E&M
type 2. To change the E&M jumper position, perform the
E&M jumper block positioning procedure.