MultiVOIP Quick Start Guide
48
parameters, and regional telephone parameters for each
channel.
Configure each channel for the type of interface you are
using. Channel 1 displays by default on the Interface tab.
To change the channel number, select the channel you
want to configure from the Select Channel list.
Feature options are enabled or unavailable according to
the interface type that you select. The Inter Digit T ime
check box is available for all interface types. This option
defines the maximum amount of time that the unit will wait
before mapping the dialed digits to an entry in the Phone
Directory Database. If too much time elapses between
digits, and the wrong numbers are mapped, you will hear a
rapid busy signal. If this happens, it will be necessary to
hang up and dial again. The default is 2 seconds.
6. The Interface group defaults to FXS (Loop Start). Select
the interface option that corresponds to the interface type
being connected to the Voice/Fax Channel 1 jack on the
back panel of the MultiVOIP 400/800.