Multiquip DCA-300SSK SERIES - GENERATOR OUTPUTS/GAUGE READING, Maximum Amps, Model, DCA300SSK

DCA-300SSK SERIES — GENERATOR OUTPUTS/GAUGE READING

Maximum Amps

Table 10 shows the maximum amps the generator can pro- vide. DO NOT exceed the maximum amps as listed.

Table 10. Generator Maximum Amps

Model:	DCA300SSK
	Series
Rated Voltage	Maximum Amps
Single Phase	2000 amps (4 wire)
120 Volt
Single Phase	1000 amps (4 wire)
240 Volt
Three Phase	720 amps
240 Volt
Three Phase	360 amps
480 Volt

How to Read the Output Terminal Gauge.

The AC ammeter and AC voltmeter change-over switches on the control panel DO NOT effect the generator output. They are provided to help observe how much power is being supplied, produced at the UVWO terminals lugs.

When the voltage change-over board is jumpered for 3Ø, 240V operation (See Figure 15), place the AC Voltmeter Change-Over Switch (Figure 16) to the W-U position and the AC Ammeter Change-Over Switch (Figure 18) to the U or W position to read the output on the selected leg.

Figure 16. AC Voltmeter	Figure 17. AC Voltmeter
Change-Over Switch	Gauge
	(Volt reading on W-U Lug)

40

2060

0 75

A

Figure 18. AC Ammeter	Figure 19. AC Ammeter
Change-Over Switch	(Amp reading on U lug)

NOTE	The ammeter and voltmeter
	gauges are only active when the
	UVWO terminals are in use.

Figure 15. Voltage Change-Over Board 240V Configuration

DCA-300SSK SERIES — PARTS AND OPERATION MANUAL (STD)— REV. #4 (03/27/06) — PAGE 29