Boss Audio Systems BR-900CD owner manual Editing the Mastering Tool Kit Settings, 103

Mastering

5.Use the TIME/VALUE dial to select the Preset/Song/ User patch and number for the Mastering Tool Kit.

“Mastering Tool Kit Patch List” (p. 205)

6.Press [EXIT] to return to the Play screen.

The overall volume is adjusted by the MASTER fader. At this time, raise the volume as high as possible without allowing the sound to distort.

7.Press [REC].

[REC] flashes in red and the BR-900CD enters the

recording standby state.

fig.01-804

Flash

Editing the Mastering Tool Kit Settings

To create a new patch, select the patch that most closely resembles the sound you have in mind from the effects patches already stored in the unit, then edit its settings.

If you wish to save the effect settings that you edited, save them as a user patch or song patch.

1.Carry out Steps 1–3 from p. 102, and switch to Mastering mode.

2.Press [EFFECTS] (MASTERING TOOL KIT).

The Mastering Tool Kit selection screen appears.

fig.01-806d

	P: Preset / S: Song / U: User
Algorithm	Bank	Number Patch Name
Name

Section 3

8.Press [PLAY].

[REC] stop flashing in red and instead light solidly, and

recording starts.

fig.01-805

Lit

9.When you finish mastering, press [STOP].

*During updating, “Keep power on!” appears in the upper line of the display, while the lower line shows what is being processed.

3.Use the TIME/VALUE dial to select the Preset/Song/ User and number.

4.Press CURSOR [ ] to move the cursor to “EDIT,” and press [ENTER].

The display switches to the Mastering Tool Kit Edit screen, which shows the algorithm (the effects used,

shown in the sequence they are connected).

fig.01-807d

You can also display this screen directly by pressing [ENTER] while the cursor is positioned at the Preset/Song/ User or number.

103