Multiquip DCA300SSCU manual Output Terminal Panel Connections, UVWO Terminal Output Voltages

OUTPUT TERMINAL PANEL CONNECTIONS

UVWO Terminal Output Voltages

Various output voltages can be obtained using the UVWO output terminal lugs. The voltages at the terminals are dependent on the placement of the jumpers plates (6) on the Voltage Change-Over Board and the adjustment of the Voltage Regulator Control Knob.

Remember the voltage change-over board determines the range of the output voltage and can be configured in two different positions that provide 6 different output voltages at the UVWO output terminals. The generator is shipped from the factory in the 240V configuration. The voltage regulator (VR) allows the user to increase or decrease the selected voltage.

3Ø-240V UVWO Terminal Output Voltages

1.Jumper the voltage change-over board for 240V operation as shown in Figure 18.

3.Turn the voltage regulator knob (Figure 20) clockwise to increase voltage output, turn counterclockwise to decrease voltage output. Use voltage regulator adjustment knob whenever fine tuning of the output voltage is required

Figure 20. Voltage Regulator Knob

1Ø-240V UVWO Terminal Output Voltages

1.Make sure the voltage change-over board is jumpered for 240V operation as shown in Figure 18.

2.Connect the load wires to the UVWO terminals as shown in Figure 21.

Figure 18. Voltage Change-Over Board 240V

Configuration

2.Connect the load wires to the UVWO terminals as shown in Figure 19.

Figure 19. UVWO Terminal Lugs

Figure 21. UVWO Terminal Lugs 1Ø-240V

Connections

1Ø-120V UVWO Terminal Output Voltages

1.Make sure the voltage change-over board is jumpered for 240V operation as shown in Figure 18.

2.Adjust voltage regulator knob (Figure 20) for an output of 208V to obtain 120V at the UVWO terminals.

3.Connect the load wires to the UVWO terminals as shown in Figure 22.

Figure 22. UVWO Terminal Lugs 1Ø-120V

Connections

page 28 — DCA300SSC / DCA300SSCU Gen. • operation and parts manual — rev. #1 (08/10/11)