Multiquip operation manual HHXG5 Controls and Indicators Clamshell Open

CONTROLS AND INDICATORS

31
33	35	34	41
		23	35
39				36

42 37

32 38

43 40

44

35

Figure 4. HHXG5 Controls and Indicators (Clamshell Open)

31.Radiator/Filler Cap — Holds coolant or water necessary to keep engine at a safe operating temperature. Remove this cap to add water or antifreeze.

32.Blade Speed Pedal — Slow blade speed is accomplished by slightly depressing the foot pedal while maximum blade speed is accomplished by fully depressing the pedal.

33.Overflow Bottle — Supplies coolant to the radiator when radiator coolant level is low. Fill to indicated level as shown on bottle.

34.Engine Oil Filler Cap — Remove this cap to add engine oil.

35.Clamshell Securing Bolt Location (4 places) — Remove to open clamshell.

36.Clutch and Belt — Drive Pulleys transfer power from the engine to the gearboxes

37.Spare Belt Carrier — Contains a spare drive belt for expedient belt replacement.

38.Battery—Provides+12VDCpowertotheelectricalsystem

39.Right Side Clamshell — Remove two bolts to open for service and maintenance access.

40.Left Side Clamshell — Remove two bolts to open for service and maintenance access.

41.Retardant Spray Filler Cap — Remove this cap to add spray retardant.

42.Burp Tank — Hydraulic Fluid top-off point.

43.Test Port-Hydraulic Pressure — Hook test guage to test port to determine hydraulic pressure during operation.

44.Retardant Spray Control Button — Located on both joysticks.When pressed, allows retardant spray to flow through the spray nozzle.

The following section is intended as a basic guide to the ride-on trowel operation, and is not to be considered a complete guide to concrete finishing. It is strongly suggested that all operators (experienced and novice) read “Slabs on Grade ” published by the American Concrete Institute, Detroit Michigan.

HHXG5 RIDE-ON TROWEL • operation manual — rev. #1 (10/25/10) — page 19