INSPECTION
This section is intended to assist the operator with the initial
the gearbox, and refill with ISO 220 A GMA GR 5 EP oil.
this section be read carefully before attempting to use the trowel in the field.
DO NOT use your
WARNING
Failure to understand the operation of the HHX could result in severe damage to the trowel or personal injury.
FILL PLUG
SIGHT GLASS (OIL CHECK)
DRAIN PLUG
Figure 8. Gearbox Oil Plugs
See Figure 2, Figure 3, and Figure 4 for the location of any control or indicator referenced in this manual.
Engine Oil Level
1.Pull the engine oil dipstick from its holder.
2.Determine if engine oil is low (Figure 7), add correct amount of engine oil to bring oil level to a normal safe level (Table 4)..
CAUTION
DO NOT overfill engine oil. Oil level should not be above the top fill line.
DIPSTICK
SAFE
OPERATING
MAXLEVEL
ADD OIL
MIN
Figure 7. Engine Oil Dipstick
Gearbox Oil Level
1.Check the gearbox oil level in both gearboxes by viewing the sight glass at the rear of the gearbox. See Figure 8.
2.The oil level of the gear box should be at the
Fuel
To determine if the engine fuel is low, view the sight gauge on the side of the fuel tank. If fuel level is low, fill with unleaded gasoline.
WARNING
Handle fuel safely. Motor fuels are highly flammable and can be dangerous if mishandled. DO NOT smoke while refueling. Do not attempt to refuel the
WARNING
Never store the
HYDRAULIC FLUID FILTER
To determine if the hydraulic fluid filter needs to be changed, view the sight gauge above the hydraulic filter located beneath the foot platform.. If the gauge reads in the red area, indicating a fiter
page 22 — HHXg5