Multiquip MQ62TDD manual Maintenance Engine, General Inspection Air Cleaner

MAINTENANCE (ENGINE)

TABLE 6. INSPECTION/MAINTENANCE			10 Hrs	250 Hrs	500 Hrs	1000 Hrs
			DAILY
	Check Engine Fluid Levels		X
	Check Air Cleaner		X
	Check Battery Acid Level		X
	Check Fan Belt Condition		X
	Check for Leaks		X
	Check for Loosening of Parts		X
ENGINE
	Replace Engine Oil and Filter*1			X
	Clean Air Filter			X
	Check Fuel Filter		X
	Clean Unit, Inside and Outside			X
	Change Fuel Filter				X
	Replace Air Filter Element*2				X
	Check all Hoses and Clamps					X
	*1	Replace engine oil and oil filter at 100 hours, first time only.
	*2	Replace primary air filter element when restriction indicator show RED

General Inspection

Prior to each use, the pump should be cleaned and inspected for deficiencies. Check for loose, missing or damaged nuts, bolts or other fasteners. Also check for fuel, and oil. Use Table 6 as a general maintenance guideline Engine Side (Refer to the Engine Instruction Manual)

Air Cleaner

Every 250 hours: Remove air cleaner element (Figure 16) and clean the heavy duty paper element with light spray of compressed air. Replace the air cleaner as needed.

Air Cleaner with Dust Indicator

This indicator (Figure 16) is attached to the air cleaner. When the air cleaner element is clogged, air intake restriction becomes greater and the dust indicator signal shows RED meaning the element needs changing or service. After changing the air element, press the dust indicator button to reset the indicator.

Figure 16. Air Cleaner

The air filter should not be changed until the indicator reads “RED”.Dispose of old air filter it may not be cleaned or reused.

PAGE 28 — MQ62TDD TRASH PUMP • OPERATION AND PARTS MANUAL — REV. #0 (07/30/09)