ŸWhen the external power fails and the TP6000 is working on the optional UPS battery power, the green LED flashes.
ŸWhen the optional UPS battery is close to full discharge from supporting the TP6000 in the absence of the external power, the orange LED flashes rapidly.
ŸWhen the TP6000 is turned off and the external power is not present, the LED is off.
This system will not allow power up in the absence of an external power
supply.
The maximum total power consumption of the external power supply unit is 1.6 A at 115 V AC or 0.8 A at 230 V AC.
Hardware Switch
The power switch located at left side of the main unit is a slide type switch. This switch controls the power on/off of the system. This switch turns the system on when slid downward, only when external power is present. The switch will always spring back to its original position when pressure is removed. This switch turns the system off when slid downward again during power on status. However, if the system hangs due to any reason such as software resource conflict a simple slide of the switch may fail to turn off the power. In this case, please utilize the forced power off feature by pressing the switch downward, and holding for within 10 seconds. In case the turmoil is so vigorous that some hardware registers may be confused causing trouble for system restart or even this forced power off, please disconnect the UPS battery if installed and the AC power supply for few minutes. This may allow all hardware registers to reset.
This switch can also be programmed as an ON only switch. That means, if the application program issues a command compliant with the TP6000 series technical manual, this switch will always turn the system on when activated, but will not power off the system when depressed again (the forced power off feature will not work in this mode). When using this feature, please make sure that the software application has the ability to power off the machine.
TP6000 USER’S MANUAL 4 - 3
