NAD L56 owner manual Learning Codes from Other Remotes, Cancel Operation, Punch-Through

IDENTIFICATION OF CONTROLS

LEARNING CODES FROM OTHER REMOTES

Begin by positioning the HTR L76 “nose-to-nose” with the source remote so the two devices’ infrared windows are about 2 inches apart.

• Enter Learning Mode: On the HTR L76, simultaneously press-and-hold for 3 seconds both a Device

Selector key and the “OPEN/CLOSE” key (just below the “DISP” key), until the Learn LED at the centre of the HTR L76 turns steady green.

•Press the HTR L76’s function key you wish to teach a command; the Learn LED will turn amber.

•Press-and-hold the function key on the source remote: The HTR L76’s Learn LED will flicker amber for a second or two, then turn solid green. The command is learned.

•Press the HTR L76’s Device Selector key again to exit the learning mode.

If the Learn LED does not flicker amber you may need to vary the distance between the remotes. If the Learn LED turns red rather than green, that particular command of that source remote command could not be learned.

CANCEL OPERATION

You can cancel configuring a key, by pressing the active Device Selector key before the learn process is complete; the Learn LED will turn red.

Example: Learning “VCR Pause”:

Position the HTR L76 and your VCR player’s remote as described above.

•On the HTR L76, simultaneously press-and-hold “VCR” and ; the Learn LED turns steady green.

• Press the HTR L76’s (pause) key; the Learn LED turns amber.

•Press-and-hold the VCR player’s remote’s pause key; the HTR L76’s Learn LED flickers amber and then turns solid green. The command is learned.

•Press “VCR” again to exit the learning mode.

PUNCH-THROUGH

The HTR L76’s “punch-through” function allows you to retain a function key from one Device Select “page” on another, so that, for example, the AMP “SURR MODE” function might still control the L76 when the DVD Device Selector page is active

NOTE
The HTR L76’s “VOL” and “MUTE” keys are pre-programmed as “punched-through” for all Device
Select pages: “VOL” will operate the L76’s master-volume regardless of the currently selected device.
The “SURR.” “CENTER,” and “SUB” Channel Volume controls similarly are pre-programmed as	GB
punched-through.

To set a punch through, after entering the Learning Mode, and pressing the desired key to be punched- through, simply press the device key twice of the device to punch through to. The status LED will turn green; press the Device Selector key again to exit Learning Mode.

Example: Punch-through the from the DVD “page” to the AMP “SURR MODE” key:

•On the HTR L76, simultaneously press-and-hold “DVD” and (OPEN/CLOSE); the Learn LED turns steady green.

•Press “SURR MODE”; the Learn LED turns amber.

•Press “AMP” twice; the Learn LED turns green.

•Press “DVD” again to exit the learning mode.

13